Small glass and brass oil lamp


Small clear glass kerosene lamp with brass burner.


Lamp glass diameter: Ø 32 mm.

Wick included.


Fill the lamp with kerosene lamp oil:

The kerosene lamp must be switched off and cold when filling.
- Remove the burner glass and unscrew the burner.
- Fill the lamp with oil, approximately 2/3. Use a funnel to prevent overflow.
- Replace the burner with the wick and allow the wick to absorb the oil for approximately 20-30 minutes.
- Light the lamp and adjust the flame height using the screw on the side of the burner.
- Replace the burner glass.

Note that you may need to adjust the burner glass so that it is straight, use the metal clips on the gallery to stabilize it.

To extinguish the light:

Extinguish the flame by slowly lowering the wick until the flame goes out.

Change wick:

The old wick is removed from the burner from below and the new one is inserted from below and screwed in at the correct height.

Important: The burner glass is extremely hot when the lamp has been burning for some time. Place the lamp on a flat surface, away from any flammable materials. Make sure that the area above the lamp, about 1 meter away, is clear.


Data sheet

19 cm
Ø 7 cm

You might also like

  • Register

New Account Register

Already have an account?
Log in instead Or Reset password